DM800 HD - ERR01 NO CA FOUND

[elprofesor]

Hello,

I flashed my dreambox DM800 HD with the openpli image ( openpli-2.1-beta-dm800-20140510.npi) and now i get the error 'ERR01 NO CA FOUND' when i boot it. It cannot go to dhcp mode so it's not accessible over network. Could you please advise what is the error and suggest any solutions?

Many thanks!

[The Founder]

Hello,

I flashed my dreambox DM800 HD with the openpli image ( openpli-2.1-beta-dm800-20140510.npi) and now i get the error 'ERR01 NO CA FOUND' when i boot it. It cannot go to dhcp mode so it's not accessible over network. Could you please advise what is the error and suggest any solutions?

Many thanks!

yes, this mini usb port, is the serial port for this receiver. you can flash through serial, a correct one image for your receiver, and recover it.

also,there was a recovery tool by yassinov, which had the bootloader for most dmm models (original and clone

[Zaam]

Best tool to use is Japhar Flasher, this is a patched Dreamup.

Connect both Micro USB and ethernet cable fill out the ip ranges. and select the USB cable port.

Power off the SE then click connect in japhar flasher then power on the SE.

It should then connect and allow you to flash an image

[admin]

Hi thanks for the post

Dreambox OptiFlasher Enigma2 EDition [DM800/DM800SE]

Version 1.0.3

Main Features:


-Performing IMAGE Writing Operation [NFI]
-Performing IMAGE Backup Restore [NFI]
-Performing Boot Loader Writing/Update Operation [NFI]
-Performing Manual/Auto Reboot


Best regards , yassinov

IMG_1462.png (83.88 KiB) Viewed 1957 times

OptiFlasher v1.0.3 Enigma2 EDition By YASSINOV.zip

(1.68 MiB) Downloaded 65 times

Hope solve your problem

[elprofesor]

Hello,

Many thanks for the prompt reply and for your help, really appreciated! Do you also have a link for the right image for my box? My bootloader is version 84.

Best regards!

[admin]

Hello,

Many thanks for the prompt reply and for your help, really appreciated! Do you also have a link for the right image for my box? My bootloader is version 84.

Best regards!

In Image :
- CCcam 2.2.1
- Mgcamd 1.35a
- Green Button to use plugin Dream cam Center
- New --oo--s for Emu's
DOWNLOAD
http://www.mediafire.com/?i7d551wpnsf395n

[elprofesor]

Dear admin,
Many thanks for sharing the image with me. I accidentally flashed the original openpli image to my cloned box and I am now unable to use Dreamup in order to reflash the box using both serial and rj45 cables. Hopefully, the OptiFlasher tool can do the job.
Best regards!

[elprofesor]

I will also try Japhar Flasher which Zaam suggested!

[elprofesor]

Hello all,

I managed to successfully flash that image but I still get the same error. Do I need to flash another image? Or do I need to flash bootloader for sim 2.01 after flashing the image? Many thanks for your help!

[elprofesor]

Screenshot attached.

Sim 201 team 84B