Sat-Forum.Net

Hello everyone,

I need to run two different cams at the same time...

the issue is that when i select one, the other stops ... but i need them both active

is there a "how to" to this problem?

Any help would be greatly appreciated

Black Hole Image allows you to select a cam for a specific provider via the autocam fuction

thanks for your answer, but the cams must be active anytime... not just when you zap... the device has two tuners ... one from cable and one from sat.... i need them to be active all the time...

UniVerseHub wrote: ↑11 Nov 2022, 00:12 thanks for your answer, but the cams must be active anytime... not just when you zap... the device has two tuners ... one from cable and one from sat.... i need them to be active all the time...

Nothing

You can use two readers in one oscam

yes, that'd be simple, wouldn't it!? but the problem is that ... one must read a card in the box and one is coming from a plugin.... so... osc@m, with reader must be on always ... but when i select the cam from the plugin obviously the osc@m goes off

buy another box & share with oscam to the main box..